A fireplaces is defined as a space heater and space heaters are intended to heat a space directly, unlike a central heating furnace, which supplies its heat to the house through a system of ducts. But because modern houses conserve energy more effectively than older houses and need less heat to stay warm, it is now possible to heat an average-size modern home with a single space heater, provided it is located in the main living area.

If you want to heat most or all of your house with a fireplaces, try to meet these two objectives: First, the heater should be located in the area where the family spends most of its time. And second, there should be ways for the heat to flow to other parts of the house. These conditions are not usually difficult to meet, but they do need to be planned. 

 Put the stove in the area you spend your time    

Choosing the right location for the stove may be the most important decision you must make. The heater should be located in the part of the house you want to be the warmest. This is usually the main floor area where kitchen, living and dining rooms are located and where families normally spend most of their time. By locating the space heater in this area, you will be warm and comfortable while you eat meals and relax.

  For heat upstairs, don't put the stove in the basement

A basement is not a good location for effective space heating. Although the heated air from the stove does tend to rise to higher levels of the house, this movement is normally too slow and limited to provide comfort on the upper floor. Usually, in an effort to keep the main floor living spaces comfortably warm, the basement is overheated. This wastes fuel and the frequent high firing can damage the stove. Unfinished basements are particularly bad locations because too much of the heat is absorbed by the walls and lost to the outside. Also, fireplaces operating in basements may over-fire or smolder without anyone noticing. The basement is only a good location for a space heater if your family spends much of its time in a basement family or recreation room.



fireplacesA fireplaces may have: a foundation, a hearth, a firebox, a fireplaces mantel, an ashdump door, a fireplaces crane, a cleanout door, a grate, a lintel, a lintel bar, overmantel, a fireplaces breast, a damper, a smoke chamber, a throat, aflue, a fireplaces chase, a crown, a cap, a shroud, or a spark arrestor.

fireplaces types:

  • Masonry (brick or stone fireplaces and fireplaces. This type of fireplaces is popular due to its nostalgic qualities.
  • Manufactured ("prefab") fireplaces with sheet metal fire boxes.

Masonry and prefab fireplaces can be fueled with wood, natural gas, biomass and lp/propane fuel sources.

  • Ventless fireplaces (duct free/rom-venting fireplaces) that are fueled by either gel, LP/bottled gas or natural gas. Some states and local counties have laws and ordinances regarding these types of fireplaces. They require the least installation and are the most efficient fireplaces. The gas burning version of a vent free fireplaces while using less fuel, burns that fuel at close to 100% efficiency. They must be sized appropriately to the area to be heated. Aside from the heat output there are also air quality control problems due to the amount of moisture they release into the room air, and oxygen sensor and carbon monoxide sensors are safety essentials.

fireplaces/flue types:

  • Masonry (brick or stone fireplaces and fireplaces) with or without tile lined flue. Unreinforced masonry fireplaces do not stand up to earthquakes well.
  • Reinforced concrete fireplaces. Fundamental flaws (the difference in thermal expansion rates between steel rebar and concrete which caused the fireplaces flues to crack when heated) bankrupted the US manufacturers and obsoleted the technique.[citation needed] This is evidenced by vertical cracks on the exterior of the fireplaces.
  • Metal-lined flue: Double or triple walled metal pipe running up inside a new or existing wood framed or masonry chase

Newly constructed flues may feature a chase cover, a cap, and a spark arrestor at the top to keep small animals out and sparks from exiting the fireplaces cavity.
Name
Street Address
City
State Zip Code
Service
E-Mail Address
Phone
Additional Information